over temperature tj 140j t ypically (u1) detect on main control ic specification model lplc-18-350 lplc-18-700 dc voltage range rated current rated power output line regulation load regulation setup, rise time voltage range frequency range efficiency(typ.) ac current input inrush current(max.) leakage current working temp. working humidity storage temp., humidity temp. coefficient vibration mtbf dimension others note packing over voltage 6~48v 6~25v 350ma 700ma 16.8w 17.5w 300mvp-p 250mvp-p 5.0% 1.0% 3.0% 3600ms, 150ms / 115vac 47 ~ 63hz 82% 80% 0.5a/115vac 0.25ma / 120vac 20 ~ 90% rh non-condensing -40 ~ +80 , 10 ~ 95% rh 0.2%/ (0 ~ 50 ) 10 ~ 500hz, 2g 10min./1cycle, period for 60min. each along x, y, z axes 1. all parameters not specially mentioned are measured at 115vac input, r ated load and 25 of ambient temperature. 2. ripple & noise are measured at 20mhz of bandwidth by using a 12" twisted pair- wire terminated with a 0.1uf & 47uf parallel capacitor. 3. tolerance : includes set up tolerance, line regulation and load regula tion. 4. derating may be needed under low input voltage. please check the static ch aracteristic for more details. 5. the power supply is considered as a component that will be operated in combi nation with final equipment. since emc performance will be affected by th e complete installation, the final equipment manufacturers must re- qualify emc directive on the complete installation again. 6. suitable for indoor use or outdoor use without direct sunlight exposur e. 18w single output switching power supply constant current mode power supply 90-132vac input only fully encapsulated with ip67 level (note.6) protections:short circuit / over voltage / over temperature cooling by free air convection pass lps 100% full load burn-in test suitable for led lighting and moving sign applications high reliability / low cost 2 years warranty class power unit, no fg l p l c - 1 8 s e r i e s ripple & noise (max.) note.2 voltage tolerance note.3 environment safety & emc (note 5) protection file name: lplc-18-spec 2011-11-08 safety standards withstand voltage isolation resistance i/p-o/p:3kvac hold up time (typ.) 20ms/115vac at full load 50.4~ 60v 28.75~ 33.75v protection type : shut off o/p voltage, clamping by zener diode 140*30*22(l*w*h) cold start 40a/115vac protection type : hiccup mode, recovers automatically after tempera ture goes down ip67 approved; design refer to ul1310 class 2,tuv en60950-1, en61347- 2-13, can/csa c22.2 no. 223-m91 1200.6k hrs min. mil-hdbk-217f (25j) 0.175kg; 70pcs/13.3kgs/0.71cuft features : ip67 lps i/p-o/p:>100m ohms / 500vdc / 25 / 70% rh (lvd) 90 ~ 132vac 127 ~ 186vdc -30~ +70 (refer to "derating curve") 8.0% current accuracy compliance to en55022 (cispr22) , fcc part 15, class b en61000-3-2 class a, en61000-3-3 compliance to en61000-4-2,3,4,5,6,8,11, en55024, light indust ry level, criteria a emc immunity emc emission
mechanical specification unit:mm derating curve static characteristics ambient temperature ( ) load (%) -30 0 10 20 30 40 50 70 20 40 60 80 100 (horizontal) block diagram detection pwm circuit emi filter power switch- filter & rectifiers +v -v i/p ing control 50 18w single output switching power supply l p l c - 1 8 s e r i e s ul 1015 18awg ul 1015 18awg input voltage (vac) 60hz 90 100 110 105 115 125 120 132 load (%) 90 100 80 70 60 50 40 fosc : 67khz rectifiers 60 140 30 22 +v(red) -v(black) ac in dc out ac/n(blue) ac/l(brown) 300 20 300 20 3.6 3.6 3.5 3.5 3.5 3.5 file name: lplc-18-spec 2011-11-08
|
